Warning: mysql_fetch_array() expects parameter 1 to be resource, boolean given in /home/snoring/public_html/gen/information.php on line 68
Information - SnoringCure.ca

Information - SnoringCure.ca

SleepSoft Use Instructions

SleepSoft® with special filters Special filters Plastic case
SleepSoft® with special filters Special filters Plastic case

 

To insert the ear plug protector, you can use the insertion tube.
Rotate the insertion tube until the ear plug protector fits snugly.
Slide the tube over the filter stem, slightly lift you ear, and insert the ear plug protector into the ear.
When ear plug protector is to wide, If you have a narrow ear canal, you can easily alter the fit of the ear plugs protector, by carefully trimming the largest lamella, to shape, using a sharp pair of scissors.
The ear plug protector may protrude slightly too far from you ear, carefully remove the filter from the ear plugs protector. Then cut a short section off the end of the end of the stem, and replace the filter in it.


Average attenuation value:

Frequency in Hz

125 Hz

250Hz

500 Hz

1 kHz

2 kHz

4 kHz

8 kHz

Yellow filter Average attenuation value in dB

18,8 dB

15,6 dB

16,0 dB

18,5 dB

27,7 dB

28,9 dB

22,0 dB

125 Hz sound reduced by 18 dB. Frequency is measured in cycles per second, or Hertz (Hz). The higher the pitch of sound, the higher the frequency. 125 Hz are low tones, 8 kHz (8000 Hz) are high tones. The decibel (abbreviated dB) is used to measure the intensity of a sound, and is limited to peak sound pressure level. At 2 kHz, the unfit on average attenuates 27,7 (dB) decibels. Our hearing can perceive noises from 0 dB (hearing threshold) to 140 dB (pain limit).

Information: We do not take responsibility for any of the content you may find on these sites. If you have a personal health concern, please consult your qualified health practitioner.